How Do You Clean Your Iphone Charging Port

How do I clean the charging port on my phone?

However, the steps for how to clean an iPhone charging port or an iPad USB-C charging port are simple: Turn off your device and use the can of compressed air or the bulb syringe to clean out the charging port. Blast a few short bursts and see if any dust falls out.
To use, simply point the nozzle into the charging port and give it a good blast. This should loosen the dust enough to make it fall out. WARNING: Do not blow into the port with your mouth. Unlike the compressed air, your breath contains water vapour that could damage the sensitive electronics inside your phone.
Whether you knew it or not, your iPhone might have a charging problem because the port is unclean or dropped the phone in water. That means you have to work out a plan to clean the iPhone port. Even if the outside may look clean, an iPhone charging port may not. So, the only way to repair it is to clean the port.
If using compressed air, make sure you’re holding the can upright to avoid getting water inside the port. Turn your phone back on and try charging the battery. If your phone won’t charge, turn it off again and use a toothpick to gently scrape or pull out any debris in the port.

How to clean iPhone charging port with toothpick?

Holding your iPhone so the backside is facing up, place the toothpick inside the charging port. Scrape against the back wall of the port. This will take a lot of poking and scraping. Continue to do this until the debris starts to come loose. You’ll see a bit of gunk come out on the toothpick.
Use a Toothpick. This is a popular method to clean an iPhone charging port but should only be used as a last resort. That’s because the charging port contains sets of pins, and those pins are fragile. If you stick a toothpick (or paperclip or thumbtack) into this port, you could damage those pins.
If you stick a toothpick (or paper clip or thumbtack) into this port, you could damage those pins. Once the pins are damaged, the only option is to replace the port. To clean the port with a toothpick: Hold the phone with one hand and the toothpick in another. Gently insert the toothpick into the port.
[6] Gently brush out any debris. Using the head of the toothbrush, carefully swipe the bristles along the charging port to remove any debris. If you observe any particles further within the charging port, use the tip/corner of the bristles to reach inside. [7]

How to clean an iPhone charger with alcohol?

Alcohol isn’t the perfect way to go, but you can still use it to get the elements clogging your iPhone’s charging port. You can use it in two ways without damaging the device. First, alcohol can be used together with the cotton (optional) attached to the toothpick.
It involves using a paper towel (Q-tip/cotton round) to form a gentle, nonabrasive, and dry tip that can enter the charging port. Avoid using any chemicals or other cleaning agents on the material or in the charging port, as these may cause internal damage.
Follow these steps to clean your iPhone charging port using a toothpick: Step 1: Use the flashlight to identify which kind of dirt is in the port. Next, switch off your phone, then place it upside down (backside facing up) on a bench or hold it in your hands in that same way.
That way, using a toothpick will prevail. The most preferred method is using wooden items, especially toothpicks, which are known to clean the charging port properly. Compared to sharp metallic objects, toothpicks, especially the round-tipped ones are best as they’re supple and unlikely to damage the charging port.

https://youtube.com/watch?v=BwVOx6x-8NY

Can you use compressed air to clean your iPhone’s charging port?

Below are better ways to clean the charging port: You can use compressed air to remove dust and dirt from the iPhone charging port. It’s the best way of doing so as long as it’s carefully done. The secret to doing this is to patiently spray a little air over the port at a time.
Apple doesn’t recommend using compressed air to clean iPhones. However this is a well-known, successful method, so we’ve given directions for those who choose to use it. Using a can of compressed air, such as Falcon Dust, hold it upright and give the port a few short blasts to clear away any immediate dust.
If your device has a removable battery, remove it as an extra precaution. Blow compressed air into the charger port in 1 to 2-second bursts. Position the straw to the left or right side of the charging port. Press down onto the port and hold the straw steady.
Whether you knew it or not, your iPhone might have a charging problem because the port is unclean or dropped the phone in water. That means you have to work out a plan to clean the iPhone port. Even if the outside may look clean, an iPhone charging port may not. So, the only way to repair it is to clean the port.

How do I clean the charging port on my iPhone?

Top 3 Tips to Clean Your iPhone/iPad Charging Port. Using Compressed Air to Clean iPhone Charging Port. The key to using this method successfully is to ensure you spray just a little air at a time. Patience is key here. Make sure you don’t empty the whole air can all at once into the port. This can damage it.
To clean charging port for iPhone 6/5s/6s successfully using compressed air, follow the steps indicated below: Step #1: Obtain an air can. Make sure it comes with a straw (should be small) you can attach to its nozzle. Step #2: Connect the small straw to the air can.
The following steps should help you clean the iPhone lightning port using a toothpick: Step #1: Turn your iPhone off. Step #2: Hold your iPhone such that its backside faces up. Step #3: Place a toothpick inside its charging port. Step #4: Scrape slowly against the charging port back wall.
If you’re using cotton, place a toothpick on the cotton and twist until it catches and starts to wrap around the toothpick (Only use a small amount). Holding your iPhone so the backside is facing up, place the toothpick inside the charging port. Scrape against the back wall of the port.

Can you use a toothpick to clean the charging port?

Follow these steps to clean your iPhone charging port using a toothpick: Step 1: Use the flashlight to identify which kind of dirt is in the port. Next, switch off your phone, then place it upside down (backside facing up) on a bench or hold it in your hands in that same way.
Compared to sharp metallic objects, toothpicks, especially the round-tipped ones are best as they’re supple and unlikely to damage the charging port. When working with a toothpick, you’ll need a flashlight to help you see the port’s inside correctly.
If you’ve opted to use compressed air, you can also give the port a couple of blasts between toothpick insertions. You shouldn’t insert anything other than a toothpick as metal tools will cause damage and result in the whole port needing replacing — not ideal.
You can use it in two ways without damaging the device. First, alcohol can be used together with the cotton (optional) attached to the toothpick. If you decide to use some cotton with the toothpick, then dip the end with cotton in alcohol before inserting it into the port.

Can a toothpick damage a phone port?

If you’ve opted to use compressed air, you can also give the port a couple of blasts between toothpick insertions. You shouldn’t insert anything other than a toothpick as metal tools will cause damage and result in the whole port needing replacing — not ideal.
Using sharp metal objects like safety pins, paper clips, or knives can scratch your phone’s delicate components or even chip and break off inside the port. Take a softer, but more effective approach, to cleaning out your phone’s charging port with the tools Asurion Experts use:
Rice can potentially become lodged in your phone’s charging port or headphone jack, which can be extremely difficult to dislodge as it swells when exposed to liquid. Leave your device in a dry area for at least an hour with the charging port facing down. This will allow airflow into the port and force excess water to drip out on its own.
While a little debris won’t affect your phone immediately, over time, it can become so dirty that your device stops working. At Asurion, our experts help millions of customers get the most out of their favorite tech, diagnose device problems, and resolve them every day.

How do I clean the charging port on my toothbrush?

Holding the cotton down with one hand, twist the toothpick until a small amount of cotton wraps around its tip. Do this to both ends of the toothpick, if possible. You could try a cotton swab, but they are usually too thick to fit inside of a charging port.
However, the steps for how to clean an iPhone charging port or an iPad USB-C charging port are simple: Turn off your device and use the can of compressed air or the bulb syringe to clean out the charging port. Blast a few short bursts and see if any dust falls out.
The USB-C port on Android™ devices can be tough to keep clean, but there are steps you can take to rid your phone of unwanted dirt. Turn off your device and use the can of compressed air or the bulb syringe to clean out the charging port. Blast a few short bursts and see if any dust falls out.
Spray away loosened debris with more compressed air. Hold the phone, tablet, or laptop so that the charging port tilts downward toward your working surface—this will allow the dirt to fall freely from the port to the surface instead of getting stuck inside. Spray a few quick bursts inside the port again until it is clear of debris.

Leave a Comment

Your email address will not be published.